scienceworld-conductivity-tester

Instructions

Objective

Classify a target object as electrically conductive or non-conductive by using it to complete a simple circuit with a battery and a light bulb.

Core Procedure

1. Locate & Acquire Object: Teleport to the object's location and pick it up.
2. Focus on Object: Use the focus action on the object to signal intent.
3. Setup in Workshop: Teleport to the workshop. Place the object down.
4. Construct Test Circuit: Assemble the circuit on the table in this exact sequence:

a. Connect the battery anode to orange wire terminal 1.

b. Connect the battery cathode to yellow wire terminal 1.

c. Connect orange wire terminal 2 to the blue light bulb cathode.

d. Connect green wire terminal 2 to the blue light bulb anode.

e. Connect yellow wire terminal 2 to terminal 1 on the target object.

f. Connect green wire terminal 1 to terminal 2 on the target object.

1. Observe & Classify: Wait 2 steps (wait1 twice). Then look around.

• If the blue light bulb is ON, the object is conductive. Place it in the blue box.
• If the blue light bulb is OFF, the object is non-conductive. Place it in the orange box.

Key Notes

• The workshop contains all necessary components: battery, wires (orange, yellow, green), and light bulbs.
• The circuit is fragile; connect components in the order specified.
• The observation (look around) after waiting is critical for determining the bulb's state.
• This skill assumes the environment's action set and room structure as provided in the trajectory.